ELECTRICAL FAULT DESCRIPTION

SPIKES
SPIKES are high frequency oscillatory variations from a steady state level generated when reactive loads are switched. In a properly operating electrical systems, spikes can be expected to reach +/- 250 volts for durations up to 70 us decaying slowly to a steady state voltage.

More about → ELECTRICAL FAULT DESCRIPTION

TROUBLESHOOTING DIVERTER

I just want to share with my experience regarding diverter problem in my cogen project.
If you have some problem for the moving the diverter please kindly find explanation at below

1).The actuator cannot move In manual or automatic mode, the actuator cannot be moved or only in one direction. Cause : inside the pneumatic block have some moisture. (See page137 attached). Do this for problem only diverter movement.

More about → TROUBLESHOOTING DIVERTER

BASIC ELECTRICAL FORMULA

I just want to shared this formula file to you all, hopeless this can help you to calculate / convert electrical value.This file in excel. Just fill the value you want and the result you can see immediately.
Please kindly see at below picture for sample :

More about → BASIC ELECTRICAL FORMULA

TEORI DASAR LISTRIK

1. TAHANAN DARI PENGHANTAR LISTRIK
Semua bahan bagaimanapun murninya selalu mempunyai tahanan listrik, yang mana tahanan ini tergantung tahanan jenis ( ρ ) bahan itu sendiri.
Tahanan tersebut tergantung dari bahan; berbanding lurus dengan panjang dan berbanding terbalik dengan penampang penghantar tersebut.
Temperatur juga akan mempengaruhi besarnya tahanan. Baik atau buruknya tahanan suatu penghantar ditentukan oleh;

More about → TEORI DASAR LISTRIK

PEMBAKUAN ISTILAH KELISTRIKAN

Bahasa Inggris
Bahasa Indonesia

Absolute pressure             
Tekanan mutlak / absolut

Absolute air temperature         
Suhu udara mutlak / absolut

Acceptance procedure             
Prosedur penerimaan

More about → PEMBAKUAN ISTILAH KELISTRIKAN

ELECTRICAL CONVERSION

You may need to convert voltage, amperage and electrical specifications from equipment into KW, KVA and BTU information that can be used to calculate overall power and HVAC requirements. The following section addresses the process of taking basic electrical values and converting them into other types of electrical values.

The specification nameplates on most pieces of computer, radio or network equipment usually list electrical values. These values are usually expressed in volts, AMPS, kilovolt-AMPS (KVA), watts or some combination of all of the above.

More about → ELECTRICAL CONVERSION

ELECTRICAL ANSI CODE

12   ———  Overspeed (2 set points)
14   ———  Underspeed (2 set points)
21B ———  Underimpedance
24   ———   Overfluxing (V/Hz)
25   ———   Synch-check

More about → ELECTRICAL ANSI CODE